Skip to content
SunnysideLock Experts · TorontoOpen 24/7(289) 804-8437Request a visit
SUNNYSIDESUNNYSIDELOCK EXPERTS
Brass pull handle on a long rectangular plate with a keyhole, mounted on a black paneled door beside a white frame. — Toronto

Locksmith in Toronto, OntarioLocked out in Toronto?Let's get you inside.

It happens to careful people: the door swings shut, the key is on the kitchen table, and the evening stops. Our locksmith comes to Toronto, confirms the home or shop is yours, opens the door without wrecking the lock, and stays long enough to make sure the key you have still works afterwards.

Toronto, Ontario

Toronto information

Town
Toronto, Ontario
In business
15 years
Hours
Open 24/7, same fees any hour
Visits
On-site assessment preferred

2021 census · what it means at the door

  • 58%Older homes

    About 58% of homes in Toronto were built in 1980 or earlier, according to the 2021 Census.

    Period hardware on older homes deserves matching parts, not a mismatched modern set. A locksmith who works among such houses keeps finishes and styles that suit them, so a repaired or replaced lock still looks like it belongs to the door.

  • 23%

    Single-detached houses make up about 23% of homes in Toronto (2021 Census).

    Townhouses share walls but usually have their own front door and often a back door or garage. Keying both alike, and checking the strike on the less-used door, is the everyday work in a neighbourhood of attached homes.

Source: Statistics Canada, Census Profile

Locksmith services

Services for home, business and vehicle

Choose a service to see how it works in Toronto. Each page explains the situation it suits, what the locksmith looks at first, how the job is done, and how to look after the hardware afterwards. If your problem sits between two services, either page will get you to the right conversation.

Toronto

Calls like these

Technician holding a small key fob at a bench with a key-cutting machine, loose keys, and a motorcycle and scooter behind. — Toronto

Break-In Damage Lock Repair

The patio slider is sitting crooked on its track. Its latch is snapped, the frame is bowed where it was pried, and the panel no longer meets the jamb, so the house cannot be closed up for the night.

Break-In Damage Lock Repair
Technician holding a steel deadbolt to the round bore in a white door, with an open tool bag on a dark mat. — Toronto

Toronto

Plan your lock upgrade in Toronto with us

We plan visits around how people in Toronto live. A shop wants the work done before opening or after close. A family wants a time when someone is home and the dog is put away. A landlord wants the unit done between tenants. Tell us the window that suits you and we build the day around it, then call when the van is on its way.

— Sunnyside Lock Experts

  • No surprises on the doorstepWhat we described on the phone is what we plan to do. If the door tells us something different when we see it, we stop and talk before going further.
  • Helping you choose wellHardware ranges from basic to heavy-duty and simple to electronic. We explain the differences that actually matter for your door and leave the choice with you.
  • Neat work, neatly finishedHoles drilled cleanly, hardware aligned, nothing crooked or forced. A lock should look like it belongs on the door, and we take the time to make sure it does.

Hours

  • HoursOpen 24/7
  • Nights and weekendsSame fees
  • In business15 years
  • VisitsOn-site assessment

Open 24/7

How a visit goes

Replacing an existing deadbolt is usually a matter of matching rather than cutting. The locksmith measures the cross bore, the edge bore and the backset, checks the door thickness, and picks a bolt that drops into the holes you already have.

Drawing: a house seen from the street. The van pulls up, the garage door is opened for the work, then it closes level and the porch light comes on.
  1. 1 of 3

    Identifying the small lock

    Mailbox, cabinet and desk locks are small but varied. We identify the type and whether a key can be made, a cylinder replaced or the whole unit swapped.

  2. 2 of 3

    Replacing or rekeying it

    Most small locks are replaced rather than repaired because new parts are simpler than rebuilding tiny mechanisms. We fit the new cylinder and check the cam lines up with the catch.

  3. 3 of 3

    A tested key and a spare

    You get a tested key plus a spare, and a tip about where to keep it, because a mailbox key is the one people lose most.

Ask us anything about locks

(289) 804-8437

The intruder pried open our sliding patio door. Can it be made secure?

Yes. The panel goes back on its track and the broken latch is replaced, then the weaknesses a slider is born with are addressed: anti-lift blocks in the upper channel so the panel cannot be raised off its rollers, a foot bolt or pin lock through the frame at the bottom, and an auxiliary keyed lock if the latch alone is flimsy. A bowed frame may need a door installer, with the opening secured until they come.

What information helps before you come out?

Whether the door takes a skeleton-style bit key or a flat key in a round cylinder, roughly when the house was built, what the knob and bolt are doing, and whether the trouble is worse with the door closed. A photo of the faceplate in the door edge and one of the keyhole side is worth a great deal. Mention how many doors are involved and how many keys you would like afterwards.

Can the work be done while we are open?

Yes, and many businesses prefer it. The locksmith works one door at a time, finishing and testing each before starting the next, and leaves the main entrance until a quiet moment or until after closing. Doors staff are using are done last and their new keys are handed over first. Where a business would rather nobody sees the work, an early morning or after-hours window is arranged instead.

What should I have ready before the visit?

Knowing the intended use of the room, roughly how many people it holds, whether any doors are already fire-rated, and whether any of them are part of a pair helps the locksmith bring the right devices. If a fire inspector or building official has already given a note about the opening, having that note or its reference number on hand keeps the visit focused on what was actually flagged.

Does an electric strike need to match a specific lock function?

Yes. An electric strike has to suit the latch or deadlatch type it will receive, the door's handing and swing, and whether the application needs fail-safe or fail-secure operation, meaning whether the door should unlock or stay locked if power is lost. Choosing a strike without checking these against the mechanical lock is a common reason a door releases electronically but still binds mechanically.

On-site assessment preferred

Request a visit

Let's fix that lock. Start with a phone call.

Sunnyside Lock Experts

Locksmith · Toronto

Open 24/7

(289) 804-8437

15 years in business

Open 24/7 · call(289) 804-8437Request a visit